Rowe StarLink DLW-1, Руководство по обслуживанию на поле и каталог запасных частей

Страница: 27 / 158

Section 3: Venue Installation
21822662 3-1
Section 3: Venue Installation
INTRODUCTION
WARNING
The first step of the DLW-1 installation is setting up the Network in the venue. The following
procedures should only be followed once the Network is in place and has been tested by Ecast.
Also, only install a jukebox that has a working and tested hard drive in the jukebox.
Please see “Section 6: Network” if you have any questions about setting up the Network.
Please see “Section 2” if there are any questions about installing the hard drive or testing the jukebox before venue
installation.
The installation of the DLW-1 jukebox should be easy, since most of the preparation and testing has been done ahead
of time. Keep in mind that in addition to the standard installation tools, the DLW-1 jukebox installation will also
require the following:
• Standard Category 5 Unshielded Twisted Pair (UTP) Cable (approximately 200’ per venue).
• RJ-45 crimping tools
• RJ-45 cable plugs
• Staple gun and staples
In addition to 120 VAC power that is on 24 hours a day, there will be up to 4 hard wired connections to the jukebox:
an Ethernet cable from the Router, the extension speaker connections, a Remote Volume Control Unit cable, and
an IR Remote Control Sensor.
1. Standard Ethernet cable installed by the operator
2. Standard speaker cable installed by the operator
3. Standard 6 conductor modular (phone) cable installed by the operator. This cable has pin 1 to pin 6, pin
2 to pin 5, etc. and a 100 foot cable is provided. Parts to make your own can be purchased from Radio
Shack, Digi-Key, or other sources.
4. Standard 6 conductor modular (phone) cable provided and installed by the operator.