Rowe StarLink DLW-1, Руководство по обслуживанию на поле и каталог запасных частей

Страница: 14 / 158

DLW-1 Phonograph
1-4 21822662
INSTALLATION INSTRUCTIONS
Wallphono must be solidly fastened to structural members within the supporting wall.
Wallphono weighs 165 pounds (75 kg); if it falls, it could cause damage or injury.
Supplied fasteners (1-1/2” lag screws) are for wood wall stud construction. For other
types of construction, installer must provide and use appropriate fasteners.
Installing Hanger Bracket
Hanger Bracket is shipped installed to back of the Wallphono (See Figure 1-1).
1. Loosen 2 screws in slots for both Retainer Brackets that hold the Hanger Bracket in place on back of
cabinet (See Figure 1-2). Slide Retainer Bracket to side and remove. Then lower and remove Hanger
Bracket.
IMPORTANT: Save Retainer Brackets for later use after Wallphono is hung.
2. PREFERRED METHOD: At the installation location, use a level to mark a line that is exactly level and
66 9/16” (169 cm) above the floor. This will place bottom of the Wallphono at the recommended 33 1/2”
(85 cm) above the floor.
IMPORTANT: This line must be horizontal so that the Wallphono will be level.
IMPORTANT: If replacing a WP100, use the level to mark a line that is exactly 4 1/2” directly below
existing holes. This will allow for using the existing lower holes in wall and placing the Wallphono at the same
recommended height.
3. Locate wall stud locations on the horizontal line. If using supplied lag screws, drill 5/32” holes at mark.
4. Place Hanger Bracket against wall. Align Hanger Bracket holes with wall marks and attach with all
fasteners.
!
CAUTION
!
CAUTION