Rowe StarLink DLW-1, Руководство по обслуживанию на поле и каталог запасных частей

Страница: 18 / 158

DLW-1 Phonograph
1-8 21822662
VOLUME CONTROL UNIT 34032903 (Studio Sound Model Only)
This Rowelink module should be removed from bottom of phonograph and mounted remotely (behind bar, etc.).
It displays and controls the volume of the amplifier channels and microphones, turns ON/OFF (power button) the
phonograph lights, touchscreen monitor and Mars Bill Acceptor, rejects the selection playing, or adds a credit
(same as IR remote credits).
Channel Volume is displayed when the mode LED is off, and microphone volume is displayed when the mode
LED is on. The MODE key toggles between channels and microphones. Raise or lower the volume of the
channel(s) or microphone using the UP DOWN keys. The volume range is 0 to 63.
The CH, MIC, and SINGER LED’s indicate what volume is being displayed. When adjusting channel volume, if
more than one LED is on, it means those channels have the same volume. All four channels have the same volume
when shipped from the factory (see Section 9 screens Remote Control Setup – Parameters and Audio Modes –
Output Modes for other possible configurations).
AUDIO/VIDEO CONTROLLER 40917401 (Studio Sound Model Only)
This Rowelink module transforms audio signals from the Core Computer, microphones, and other sound
processors/equipment/systems into signals for the Power Amplifier. It has AVC (automatic volume control) to
correct varying recording levels, and tone control via 5-band equalizers. All adjustments and options are
programmable via the touchscreen and retained on the Core Computer hard drive.
2 CHANNEL PREAMP 61138701 (2 Channel Preamp Model Only)
This Rowelink module transforms audio signals from the Core Computer, microphones, and other sound
processors/equipment/systems into signals for the Power Amplifier. It has AVC (automatic volume control) to
correct varying recording levels, and tone control via 7-band equalizers.
1000 WATT AUDIO DIGITAL POWER AMPLIFIER 61132003
The 2-channel audio digital power amplifier is rated 1000 watts (500 per channel) RMS into a 2 ohm load. The full
volume output voltage is 32 volts (note – the full volume output voltage in previous CD phonographs is 21 volts).
The amplifier is protected against overloads and short circuits. Continuous severe overloads or shorts may shut
down the amplifier (or a channel) but will not damage it. If the overload is removed a signal will reset the amplifier
when the next selection plays.
OUTPUT TRANSFORMERS 40832108
The output transformers “step up” the power amplifiers output voltage for 70-volt extension speakers. They also
provide screw connections for selecting different power levels for extension speakers.
MARS BILL ACCEPTOR 22135603
The series 2000 bill acceptor with a 700 bill stacker operates off 120 VAC input power and outputs its pulsed
credit signal to the Rowelink Controller.