Rowe StarLink DLW-1, Руководство по обслуживанию на поле и каталог запасных частей, Страница: 111 / 158

Section 10: Operator Screens
21822662 10-15
AUDIO MODES - INPUT SELECT
This is the first of three screens. Each screen has
four modes: Audio, Standby, Background, and Mi-
crophone. Touch “Muting” or “Output Mode” to
access the other two screens.
For each mode the Audio/Video Controller can
select its front-end input signal from the Sound
Card, Stereo A, Stereo B, or Mono RCA jacks. The
microphone mode can also be set to “Unchanged”. If
you touch a button and it turns red, it indicates that
source is selected for the mode.
AUDIO MODES - MUTING
The four audio modes – Audio, Standby, Back-
ground, and Microphone – have separate mutes for
the Audio/Video Controllers Signal Outputs channels
1 and 2, Signal Outputs channels 3 and 4, Auxiliary
Outputs with AVC, and Front-end inputs. When you
touch a button, it toggles between muted and not
muted. A red button with a yellow check mark
indicates muted. The factory setting has the outputs
and inputs muted in the standby and background
modes.
Mode 1 -Audio: This is when selections are playing. It should always be set to Sound Card.
Mode 2 -Standby: When a selection finishes, the phonograph goes from Audio mode to Standby mode. It stays
in Standby until another selection plays or the Background Delay elapses. It is factory set to select the
Sound Card input.
Mode 3 -Background: When the Background elapses, the phonograph goes to the BGM mode until another
selection plays. It is factory set to select the Sound Card input.
Mode 4 -Microphone: This is when a microphone is keyed. The factory setting of Unchanged does not switch inputs
when a microphone is keyed. Select a specific input if you want the front-end to select it when a
microphone is keyed.
If you change the settings, touch SAVE to record your changes.
UNDO BACK SAVE
UNDO BACK SAVE
FOR STUDIO SOUND ONLY
FOR STUDIO SOUND ONLY