Rottler S7A, Руководство по эксплуатации и обслуживанию

Страница: 58 / 94

Section 6 Maintenance S7A S8A Manual
www.rottlermfg.com
6-20
Inner Spindle Adjustment
Turn off all power to the machine before continuing.
Remove the two screws holding the small nameplate (502-1-19C) to the front of the upper housing. Inside
the exposed opening is the spindle adjustment nut (7020). The spindle adjustment nut has holes drilled
around its perimeter to accept an adjustment rod.
Insert an adjustment rod into the spindle adjustment nut. The adjustment rod should be 1/4 - 5/16 inch
diameter and 8 to 10 inches long.
Carefully rotate the cutterhead counter-clockwise, (looking from above the cutterhead) letting the
adjustment rod move against the end of the slot. This tightens the inner spindle adjustment. The
cutterhead will be easy to turn and you should be able to feel the spring loaded detent in the adjustment
nut.
At some point the torque required to turn the cutterhead will sharply increase, immediately stop turning
the cutterhead.
Do not over tighten or severe bearing damage will occur.
Turn the cutterhead clockwise one or two detents.
Remove the adjustment rod and replace the nameplate