Rottler S7A, Руководство по эксплуатации и обслуживанию

Страница: 25 / 94

Section 4 Control Definitions S7A S8A Manual
www.rottlermfg.com
4-2
Emergency Stop
IF the Emergency stop is pushed, all power to the spindle and horizontal drive is removed. Display will still
have power and will display “EMERGENCY STOP”. To release the emergency stop, turn the button to
the right and it will “POP” out. Give the machine a minute to power up before pressing any buttons on the
control panel.
Homing
When the machine is first powered up it needs to be homed. The left and right buttons flash. The display
also tells you to home the machine. Press and hold the Left and Right buttons for two (2) seconds. The
machine will travel to the right at 50 inches per minute to find the home sensor.
Right
This button has two functions. When pressed the machine will travel to the right at 120” per minute.
Travel will continue until the button is pressed again or the right end of travel is reached.
If the spindle is on when this button is pressed, the machine will Feed to the right at the rate shown in the
display. Travel will continue until the button is pressed again or the right end of travel is reached.
Left
This button has two functions. When pressed, and held, the machine will travel to the left at 120” per
minute until the button is released or the Left end of travel is reached.
If the spindle is on when this button is pressed, the machine will Feed to the left at the rate shown in the
display. Travel will continue until the button is pressed again or the left end of travel is reached.
Note: When the machine is running an automatic cycle the Rapid Travel rate is at 160” per minute.
Spindle Start
This button will start the spindle at the speed shown in the display. The spindle will continue to run until
the button is pressed again.
The spindle will not start if any of the rapid travel or cycle buttons are active.
Relief Up
This button will put the spindle and upper housing in the full up position, about .020”. This is used at the
end of the cut in conjunction with the right travel button. It’s purpose is to allow travel to the right without
the cutter dragging back across the milled surface. The Relief Up function will operate if the spindle is
turning, but not if Feed is active. Pressing this button cancels the Up/Dn Adjust and Mill buttons.
Up/Dn Adjust
This button needs to be pressed before you use the manual hand wheel. Activating this button will put
a small amount of air pressure on the lift cylinders to counteract the weight of the spindle and upper
housing, this will make the handwheel easier to adjust. The Up/Dn Adjust function will operate if the
spindle is turning, but not if Feed is active. Pressing this button cancels the Relief Up and Mill buttons.
Mill
This button clamps the outer spindle to keep it from moving during a cut. The Mill button should be
pressed before starting a feed move. The Mill button will work if the spindle is turning, but not if the Feed
is active. Pressing the Mill button while in Relief Up will de-energize the Relief Up solenoid, allowing the
spindle to drop the .020”. A half a second later the spindle will be clamped. The Mill button cancels the
Up/Dn Adjust mode.