Rottler S7A, Руководство по эксплуатации и обслуживанию

Страница: 28 / 94

Section 4 Control Definitions S7A S8A Manual
www.rottlermfg.com
4-5
Spindle Auto Set-Up
To run Spindle Self set-up. Press and hold the SET, UP/DN and SPINDLE START button for two
seconds. The SET button will flash and the SPINDLE START button will light. Press and hold the
SET button. The spindle will enable and drive to maximum speed, the speed will be measured by the
controller and the drive will then decal and turn off the enable. Release the SET button. Press and hold
the SET button then press the RIGHT button. This will leave the Spindle Self Set-up.
Horizontal Auto Set-Up
To run the Horizontal Self set-up, press and hold the SET, UP/DN and LEFT buttons for two seconds.
The SET button will flash and the LEFT and RIGHT buttons will light. Press and hold the SET button.
The Horizontal drive will enable and Home if necessary. The control will then drive the spindle base to
the left to measure the length of the base. The Control will then drive the spindle base at full speed to the
right and then to the left to measure maximum encoder frequency. Release the SET button. Press and
hold the SET button then press the RIGHT button. This will leave the Horizontal Self Set-up.
Manual Power Up
To Manually power up the Spindle and Horizontal drive regardless of any error messages, press and hold
the SET, UP/DN, LEFT and RIGHT for two (2) seconds. Press and release the E-Stop to exit this mode.