Rottler S7A, Руководство по эксплуатации и обслуживанию

Страница: 27 / 94

Section 4 Control Definitions S7A S8A Manual
www.rottlermfg.com
4-4
Machine Parameters
To access the machine parameters press and hold the SET button then press LEFT. This will bring you to
the Password, you must still hold the set button, turn the Spindle RPM knob to read 311 then release the
SET button.
The following is a list of parameters for the machine:
1) Board serial number.
2) Input Test – a solid square below the label means the input is active.
3) Machine Type = English.
Note: You change the type by using the LEFT and RIGHT buttons.
4) Machine Type = Automatic
5) Total Horizontal Length = SF8 = 42.5, SF7 = 32.5 These will be set when the machine does the Self
Set-Up.
6) Horizontal Encoder Pulses per Inch = 2500
Note: To change numeric values press and hold the SET key while rotating the SPINDLE RPM
knob.
7) Spindle Self Set-Up
8) Spindle RPM at full drive - A = 2774
9) Horizontal Self-Set-Up
10) Horizontal Frequency at full drive – A = 8429
11) Horizontal Acceleration = 120 In/Min
12) Horizontal Rapid jog speed – A = 120 in/min
13) Horizontal Auto Jog speed – A = 160 in/min
14) Spindle Maximum RPM – A = 1800
15) Horizontal Homing Speed = 50 in/min
16) Output Test – Relief Up – LEFT = on, RIGHT = OFF
17) Output Test – Mill
18) Output Test – Vacuum
19) Horizontal Enable
20) Spindle Enable
21) Spindle Monitor
22) Horizontal Monitor
23) Spindle KBaud Rate – 1786
To exit the programming mode press and hold SET then RIGHT buttons.