Rotronic RMS-CONVERTER, Руководство пользователя

Страница: 86 / 126

RMS-Converter
E-M-RMS-Converter-V1_4.docx
Instruction Manual
© 2018 ROTRONIC AG Bassersdorf Switzerland Page 86 of 126
IMPORTANT: Rotronic recommends using a fix IP address for the RMS-CONVERTER as
well as for the digital devices. The reason being the support of the log function within the
RMS-CONVERTER in case of any interruption to the RMS server.
Step 4 Check or change the hostname and set the check mark for “Enable AutoIP address assignment:
If a DNS is active within the network, the RMS / RMS Converter can communicate based on the
host name instead of the IP address.
Step 5 Disable the discovery mode:
The device search function of HW4 and the Discovery tool uses a Device Discovery function
(ADDP). At the end of the configuration, it is meaningful to disable this feature.

Network>Network Services Settings>remove the checkmark of “Enable Device
Discovery (ADDP)”.
IMPORTANT: Parallel and unwished communication due to the opening of HW4 will be
avoided. A side effect is, that this device will not automatically be found by HW4 or the
Discovery tool anymore. To access the device via HW4, the IP address must be added
manually.
Step 6 Close connection after the following number of idle seconds:
Unwished parallel communication/requests to the Ethernet address of the Rotronic device can
cause an unwished blocking of the devices internal access to the Ethernet port. For that reason
the following setting can be done:

Serial Ports>Advanced serial settings>TCP Settings>Set a checkmark to “Close
connection after the following number of idle seconds”.