Rotronic RMS-CONVERTER, Руководство пользователя

Страница: 82 / 126

RMS-Converter
E-M-RMS-Converter-V1_4.docx
Instruction Manual
© 2018 ROTRONIC AG Bassersdorf Switzerland Page 82 of 126
4. A valve closes the “+” and “-“ connectors of the sensor internally and defines a new 0-point.
This procedure needs app. 10sec. The CRP5 will not be able to send measurement values
out during this time.
Note: A new 0-Point compensation overwrites the previous 0-Point compensation, but
doesn’t overwrites the current One point (≠0Pa) adjustment (see below).
Note: Do not use a reference value of e. g. 0.1Pa. The CRP5 would interpret it as a “One point
adjustment” as follows. In this case, the CRP5 would display a strong measurement error for
higher pressure values.
Note: The real date and reference value cannot be shown due to missing compatibility of
these systems.
One point (≠0Pa) adjustment
The CRP5 can be adjusted at an applied pressure (≠0Pa) by the customer. Rotronic recommends to
apply a pressure around the end of the measurement range.
One point (≠0Pa) adjustment at the RMS:
1. Type xxPa as the reference value and click <A Adjust> ( or <Acquire> and than
<Adjust> )
Note: Rotronic recommends to perform a 0-Point compensation before.
Note: In case of the CRP5, a customer adjustment with more than one pressure reference
value is not possible. The CRP5 accepts only these two adjustment procedures.
Note: The real date and reference value cannot be shown due to missing compatibility of
these systems.
Note: A new One point (≠0Pa) adjustment overwrites the last One point (≠0Pa) adjustment, but
doesn’t overwrites the current 0-point compensation (see above).
For relative humidity and temperature:
Humidity 2 points acquired Humidity 2 points adjusted