Rotronic RMS-CONVERTER, Руководство пользователя

Страница: 63 / 126

RMS-Converter
E-M-RMS-Converter-V1_4.docx
Instruction Manual
© 2018 ROTRONIC AG Bassersdorf Switzerland Page 63 of 126
Note: Do not use a low reference value (ex: 0.1Pa). The PF4 would interpret it as a “One point
adjustment” such as follows. In this case, the PF4 would display a strong measurement error
for higher pressure values.
Note: The real date and reference value cannot be shown due to missing compatibility of
these systems.
One point (≠0Pa) adjustment
The PF4 can be adjusted at an applied pressure (≠0Pa) by the customer. Rotronic recommends to
apply a pressure around the end of the measurement range.
One point (≠0Pa) adjustment at the RMS:
1. Type xxPa as the reference value and click <A Adjust> ( or <Acquire> and then
<Adjust> )
Note: Rotronic recommends performing a 0-Point compensation first.
Note: For the PF4, a customer adjustment with more than one pressure reference value is not
possible. The PF4 (first generation) accepts only these two adjustment procedures.
Note: For humidity, multiple points can be acquired and adjusted. For temperature only 1 or
2 points.
Step 4
Data logging: the PF4 has no internal memory, the PF4 is not battery powered. So the PF4 cannot
log during a power interruption.
In case of a communication interruption to the RMS Server, the RMS Converter logs the data of the
PF4. After the interruption, RMS requests the data from the RMS Converter.
In case of a communication interruption between the RMS Converter and the PF4, the PF4 would
not log the data.
Step 5
Sensor error: In case of one sensor error out of the two, RMS displays a sensor error for both
measurement values.
Step 6
Measurement alarm: Alarms linked to the measurement limits and programmed within the HC2 will
not be transmitted to RMS. However if the device has a display and the display is configured
correctly, the alarm will show on the display.