Rotex RKHH2E200AAV33, Руководство по установке

Страница: 23 / 42

RKHH2E-(P)AAV33
ROTEX Domestic Hot Water Heat Pump
2018.8
Installation manual
23
The upper cover of the boiler needs to be removed in
order to access the 4-core cable for remote
connection (see paragraph 0 Fig. 18). Next, roll the
cable out through the appropriate opening in the
back cover, as indicated in Fig. 14.
Fig. 14
– Cables for remote connection
6.7 Wiring diagram
Fig. 15
– Wiring diagram
7 Commissioning
WARNING!
Make sure that the equipment is connected to
the earth cable.
WARNING!
Make sure that the line voltage corresponds to
the voltage indicated on the equipment
identification plate.
The commissioning procedure should be completed by
following these steps:
•
Fill the boiler by connecting the water inlet tap
and check for any leaks from gaskets and
connections. Tighten the bolts or connections if
necessary;
•
Do not exceed the maximum permitted pressure,
indicated in the “general technical data” section;
•
Check whether the water circuit safety
equipment is working;
•
Connect the plug to the power socket;
•
When the plug is inserted, the boiler is in stand-
by, the display remains switched off, the power
key is illuminated;
•
Press the power key (see paragraph 0), the
equipment will start in “ECO” mode (default
setting) 5 minutes after pressing the key.
th
e
rm
is
to
r
3
th
e
rm
is
to
r
2
th
e
rm
is
to
r
1
port 1
(upon
request)
p
o
rt
1
(u
p
o
n
re
q
u
e
s
t)
supply
re
s
is
ta
n
c
e
d
e
fr
o
s
t