Rotel RMB-1512, Руководство пользователя

Страница: 10 / 56

10
RMB-1512 Twelve Channel Power Amplifier
Troubleshooting
Most difficulties in audio systems are the result of poor or wrong
connections, or improper control settings. If you encounter problems,
isolate the area of the difficulty, check the control settings, determine
the cause of the fault and make the necessary changes. If you are
unable to get sound from the RMB-1512, refer to the suggestions for
the following conditions:
Standby Power Indicator Is Not Lit
No main power to the RMB-1512. Check AC power connections at
the amplifier and the AC outlet. Check the front panel power switch.
Make sure that it is set to the ON position. If using signal sensing auto
power-on, make sure that a signal is present at the inputs. If using 12V
trigger power-on, make sure that a trigger signal is present at rear
panel 12V TRIG IN connector.
No Sound
If the amp is getting AC power, but is producing no sound, check the
PROTECTION INDICATORS on the front panel. If lit, see below. If
not, check all of your connections and control settings on associated
components.
Protection Indicator Is Lit
The front panel PROTECTION INDICATORS light when the RMB-1512
protection circuits have shut off the amplifier. Typically, this occurs only
when the ventilation openings are blocked,when there is faulty speaker
wiring, or after a period of extreme use. Turn off the system and wait
for the amp to cool. Then push the front panel power switch in and
out to reset the protection devices. If the problem is not corrected or
reoccurs, there is a problem with the system or the amplifier itself.
Specifications
Continuous Power Output
100 watts/channel
(20-20k Hz, <0.03% THD, 8 ohms)
Total Harmonic Distortion
(20Hz -- 22Hz, 8 ohms) < 0.03%
Intermodulation Distortion (60Hz:7kHz, 4:1) < 0.03%
Damping Factor
(20Hz-20kHz, 8ohms) 200
Input Impedance/Sensitivity 8.3 kohms/1.25 volts
Amplifier Gain
27.2db
Frequency Response (±1db) 10Hz - 40Khz
S/N Ratio
(IHF A) 105 db
Crosstalk / Separation
Speaker Impedance
Auto Turn On level (with all inputs)
Power Requirements
Power Consumption
Dimensions (W x H x D)
Weight (net)
Panel Height
> 70 db
4 ohms minimum
5mV input signal
USA:
120 volts, 60Hz Europe:
230 volts, 50Hz 660
watts
Idle: 84 watts
Standby:
＜
0. 5 watts
431 x 144 x 449 mm
17 x 5.7 x 17.8 in 10.9
kgs, 23.98 lbs 3U,
132,6 mm / 5.2 in
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.
RMB-1512 manual Book.indb 10 13/5/09 12:08:31