Fingerprint Enrollment
AYC-B7661 Installation Manual
25
3.
Present the Add card configuration card followed by the user’s
card.
If valid, the unit emits three short beeps and the LEDs blink
green. The user’s fingerprint template is then stored in the
defined record within the unit.
If an enrollment error occurs, the unit emits an error tone and
the LEDs turn red for about one second.
In 1:1 mode, up to two cards can be enrolled per user in each
slot.
5.3
Adding ID from a Card (Reader 1:N Mode)
After normal enrollment, the ID code sent to the controller is based on
the Rosslare's algorithm. However, you can link the user card's ID to
the template. In this case, the user's ID is sent to the controller instead
of the previous ID.
To add an ID from a user card:
1.
Present the Add Card card.
Both LEDs flash orange.
2.
To get to the desired record number, do one of the following:
Ask the users whose ID cards you wish to add to place the
finger linked to each record number.
Present the record number (+10 and +1) cards the number of
times required to reach the desired record number.
3.
Present the Add card card.
4.
Present the user’s card.
If valid, the unit emits three short beeps and the LEDs blink
green. The user’s fingerprint template is then stored in the
defined record within the unit.
If an error occurs because the ID from the user’s card already
exists inside the unit's database, the unit emits an error tone
and the LEDs turn red for about one second.