Fingerprint Enrollment
22
AYC-B7661 Installation Manual
3.
Present the record number (+10 and +1) cards the number of
times required to reach the desired record number, each time a
card is presented the reader emits 1 beep.
For example, to enroll a fingerprint to record number 32,
present the +10 card three times followed by the +1 card twice.
4.
Present the Enroll card. The right LED flashes green and the left
LED is off.
5.
Ask users to place their finger on the capacitive sensor.
When it successfully identifies the fingerprint, the unit emits one
short beep.
6.
Ask users to place their finger on the unit’s sensor once more.
If valid, the unit emits three short beeps and the LEDs blink
green. The user’s fingerprint template is then stored in the
defined record within the unit.
If an enrollment error occurs, the unit emits an error tone and
the LEDs turn red for about one second.
For people who cannot enroll their finger:
•
In Reader mode, there is an option to use the reader with card only
CSN or sector.
•
In Controller mode, you can enroll a user card with the Add Card
process (Section
5.3).
To delete enrolled fingerprints in 1:N mode:
1.
When the reader is in Standby mode, present the Delete card to
the reader.
Both LEDs flash orange.
2.
Present the record number (+10 and +1) cards the number of
times required to reach the desired record number.
Each time a card is presented the reader emits one beep.
For example, to enroll a fingerprint to record number 32
present the +10 card three times followed by the +1 card twice.