Ross Ultricore RCP-ME, Руководство пользователя, Страница: 64 / 98

64 • Protects and Locks RCP-ME User Guide (v4.0)

If you are protecting a destination on a level for which a routing switcher does not respond, a protect breakaway
error (
*PROT BRKWY ERR* ) occurs.
To remove the protection from a destination
1. Press the button for the protected destination.
2. Press the
PROTECT
button.
The protection indicator is removed from the screen.
Clearing Protects Held by an RCP-ME
A protect that is held by an RCP-ME prevents the crosspoint being changed by another user. A protect can be sent
to the routing switcher from any connected remote control panel. Protects can be applied at any time and are only
visible when the particular destination is selected.
To clear one protect from an RCP-ME
1. Press the destination button that has the protection applied.
The protection indicator is shown at the bottom left of the screen.
Figure 10.2 Protection Indicator for Destination
2. Press the
PROTECT
button.
To clear all of the protects from an RCP-ME
1. Open the RCP-ME Panel Config interface (see “ To open the RCP-ME Panel Config interface ” on page 22).
2. Select the Configuration tab.
3. In the Configuration section, select the Clear Protect(s) check box.
4. Send the current configuration to the device (see “ To send the current configuration to a panel ” on page 74).

Protects may be held by other remote control panels. Each remote control panel attached to a routing switcher.
1 2 3 4
SRC: Server 2
DST: Monitor
L