Ross HDC-8222A, Руководство пользователя

Страница: 18 / 52

2–4 • Installation HDC-8222A User Manual (Iss. 02)
5.
Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the back
plane of the frame. Do not over tighten.
6.
Ensure proper frame cooling and ventilation by having all rear frame slots covered with
Rear Modules or Blank Plates.
Installing the HDC-8222A
This section outlines how to install the HDC-8222A in a DFR-8300 series frame. If the
HDC-8222A is to be installed in any compatible frame other than a Ross Video product, refer to
the frame manufacturer’s manual for specific instructions.
To install the HDC-8222A in a DFR-8300 series frame
1.
Locate the Rear Module you installed in the procedure “ Installing a Rear Module ” on
page 2-3.
2. Hold the HDC-8222A by the edges and carefully align the card-edges with the slots in
the frame.
3. Fully insert the card into the frame until the rear connection plus is properly seated in the
Rear Module.
4. Verify whether your label is self-adhesive by checking the back of the label for a thin,
wax sheet. You must remove this wax sheet before applying the label to the rear module
surface.
5. Affix the supplied Rear Module Label to the BNC area of the Rear Module.
Notice
— Heat and power distribution requirements within a frame may dictate specific slot
placements of cards. Cards with many heat-producing components should be arranged to
avoid areas of excess heat build-up, particularly in frames using convectional cooling.