Ross HDC-8222A, Руководство пользователя

Страница: 17 / 52

HDC-8222A User Manual (Iss. 02) Installation • 2–3
Installing the HDC-8222A
This section outlines how to install a Rear Module in a DFR-8300 series frame. The same
procedure applies regardless of the frame or card type. However, the specific Rear Module you
need to install depends on the frame you are using.
Rear Modules for the HDC-8222A
The Rear Module for the HDC-8222A depends on the openGear frame you are installing the card
into.
• DFR-8310 series frame — When installing the HDC-8222A in the DFR-8310 series
frames, the 8310AR-030 Rear Module is required. The HDC-8222A is also compatible
with the DFR-8310-BNC frame.
• DFR-8321 — When installing the HDC-8222A in the DFR-8321 series frames, the
8320AR-030 Full Rear Module or the 8320AR-1821 Full Rear Module can be used.
Installing a Rear Module
If you are installing the HDC-8222A in a DFR-8310-BNC frame, or the Rear Module is already
installed, proceed to the section “
Installing the HDC-8222A ” on page 2-4.
To install a Rear Module in your DFR-8300 series frame
1. Locate the card frame slots on the rear of the frame.
2. Remove the Blank Plate from the slot you have chosen for the HDC-8222A installation.
If there is no Blank Plate installed, proceed to the next step.
3. Install the bottom of the Rear Module in the Module Seating Slot at the base of the
frame’s back plane. ( Figure 2.1 )
Figure 2.1 Rear Module Installation in a DFR-8300 Series Frame (HDC-8222A not shown)
4. Align the top hole of the Rear Module with the screw on the top-edge of the frame back
plane.
Screw Hole
Module Seating Slot