Ross HDC-8222A, Руководство пользователя

Страница: 33 / 52

HDC-8222A User Manual (Iss. 02) Menus • 4–7
Analog Output Tab
Table 4.6 summarizes the Analog Output options available in DashBoard.
Miscellaneous Tab
Table 4.7 summarizes the Miscellaneous options available in DashBoard.
Table 4.6 Analog Output Menu Items
Tab Title Item Parameters Description
Video Controls
Oversampling
On*
Enables the encoder oversampling of the
composite output video
Off Disables this feature
Color
On*
Enables the color on the analog/composite
output channels
Off Disables this feature
Color Bars
On
Enables the color bars on the
analog/composite output channels
Off* Disables this feature
Audio Controls
Group De-embed Group #
Specifies the group to be de-embedded
onto ANLG AUDIO OUT 1 to 4 on the
8320AR-1821 rear module
Trim 0-20.0
Provides master attenuation for the four
analog audio outputs; measured in dB
Table 4.7 Miscellaneous Items
Tab Title Item Parameters Description
Miscellaneous
Reference
a
a. Refer to the section “ Card-edge Menu System ” on page 4-10 for details on reporting the status of SW1 , position 8 .
Off* No reference is specified
Ref. 1
Selects Ref 1 to use for field locking with
720p input signals
Ref. 2
Selects Ref 2 to use for field locking with
720p input signals
Reference Alignment
Percent (read-only) Input signal and
reference signal
Reports the alignment percentage of the
input video and reference input. Note that
an Invalid Reference occurs if the input
source is not 720p or frequency mismatch
between the reference and the input source
SD V Bit correction
b
b. This feature is not fully implemented at this time. Adjusting this feature may produce undesired results.
Enable*
V-bit will always be enabled on Line 20
for the output
Disable Disables this feature
Card Settings
c
c. The buttons are disabled when
S1.1
is set for (local) card-edge control.
Save Saves the current configuration
Load Loads the previously saved configuration
Factory Defaults
c
Loads the factory default settings;
replaces any saved settings with the
factory defaults.