Remote Control Support
Use the information in this section to assist you in setting up an external device to control your server.
Remote Communications (RS-422)
Direct control of each channel transport on the server is available through ethernet communications.
The procedure for setting up a room for external control depends on the protocol you want to use.
To Configure a Room for the BVW-75 Protocol
Set up a Room to use the BVW-75 protocol to control server channels.
Note:
The BVW-75 protocol does not support clip library listing or clip loading.
1.
Launch the
Tria Config
application.
You may be prompted to allow the program to make changes on the computer, click
Yes
.
2.
Click the
RS422
tab.
3.
Click
Room
X
Configuration
and select the room you want to configure. Later you will assign this room to a
channel.
4.
In the
RS422 Protocol
area, select
BVW-75
.
5.
In the
Response Time
area, select how quickly the server executes the Clip Play command after the Clip Load
command.
•
Fast
— executes the play command immediately after the load command. This is recommended when
controlling the server from an external switcher.
•
Accurate
— executes the play command only after receiving confirmation that the clip has loaded. This is
recommended when controlling the server from an automation system.
Tria+ UHD User Manual — Remote Control Support •
55
