2.
Click the
Video
tab.
3.
In the
Video Reference Frequency
area, select the frequency you want the server to operate in.
4.
In the
Video Resolution
area, select the video resolution you want the server to operate in.
5.
In the
Video Reference Source
area, select the type of input reference signal that the server is using. This is the
video signal that is connected to the
Analog REF IN
BNC on the back of the server.
Note:
You should only use
Free Run
when the server is not receiving video from, or outputting video to, another device.
Important:
If you select
Tri-Level External Reference
or
Bi-Level External Reference
with no valid reference signal
coming into the server, you will get corrupt video on all outputs.
Tip:
Although there is only a single reference input to the server, each video processor board reports its reference independently.
Video Board 1# Reference
applies to channels A-D,
Video Board 1# Reference
applies to channels E-H, and
Video Board 3#
Reference
applies to channels I-L.
6.
In the
Horizontal Phase
area, select a timing offset for the video output relative to the reference timing.
7.
In the
Net Video
area, select whether the server can share clips with another servers on the same network (
Enable
Network Video
). All servers must have the same hardware and be operating in the same video format.
Tip:
Clips from another server can be loaded and included in a local Play List. Clips are not copied between servers. The clip is
played across the network between servers. The network connection must be maintained to use the clip on a remote server.
8.
Click
Restart Tria
. A confirmation dialog box is displayed.
9.
Click
Restart Tria
to restart the server application and services with the new setting.
10.
Click
OK
when the restart has completed to dismiss the window.
Video Router Setup
You can connect the server to an external router and control the sources feeding the server.
Note:
The router must support the Evertz
®
Quartz or Probel SW-P-08 protocol.
To Connect to a Video Router
You can change which destinations are coming into the server from the router, as well as which sources on the router are
routed to those destinations.
1.
Launch the
Tria Config
application.
You may be prompted to allow the program to make changes on the computer, click
Yes
.
Tria+ UHD User Manual — Server Configuration •
47
