General information
Page 5
UPT-6011
Version 5
be observed. External monitoring modules can be used in order to additionally increase operating safety. They are
not included in the scope of supply of the standard control system and are described in a separate document.
2.6
Line filter
ROPEX provides line filters in different power classes. The ROPEX application report lists the suitable line filter
which can be ordered accordingly.
The use of an original ROPEX line filter is mandatory in order to comply with the standards and provisions
mentioned in section 2.7 "Standards / CE marking" on page 5. This device must be installed and connected
according to the instructions contained in section "Power supply" as well as the separate documentation enclosed
with the line filter.
2.7
Standards / CE marking
The controller described here complies with the following standards, provisions and directives:
Compliance with these standards and provisions is only guaranteed if original accessories and / or peripheral
components approved by ROPEX are used. If not, then the equipment is operated on the user's own responsibility.
The CE marking on the controller confirms that the device itself complies with the above-mentioned standards.
It does not imply, however, that the overall system also fulfills these standards.
It is the responsibility of the machine manufacturer and of the user to verify the completely installed, wired and
operationally ready system in the machine with regard to its conformity with the safety provisions and the EMC
directive (see also section "Power supply"). If peripheral components (e.g. the transformer or the line filter) from
other manufacturers are used, no functional guarantee can be provided by ROPEX.
DIN EN 61010-1:2001 (2014/35/EU)
Safety requirements for electrical equipment for meas-
urement, control and laboratory use (low-voltage direc-
tive):
pollution degree 2, protection class I, measurement
category I (for U
R
and I
R
terminals)
DIN EN 60204-1 (2006/42/EG)
Electrical equipment of machines (machinery directive)
EN 55011:2009+A1:2010
EN 61000-3-2:2006-04+A1:2009+A2:2009
EN 61000-3-3:2008
EN 61000-6-4:2007+A1:2011
(2014/30/EU)
EMC generic emissions:
Group 1, Class A
EN 61000-6-2:2005 (2014/30/EU)
EMC generic immunity:
Class A (ESD, RFI, burst, surge)
Exception:
Line voltage interruption acc. to EN 61000-4-11 is not
fulfilled (this leads to a designated error message of the
controller)
2011/65/EU
Directive on the restriction of the use of certain haz-
ardous substances in electrical and electronic equip-
ment.
