Roland Sign Maker CAMM-1 PNC-1050, Руководство пользователя

Страница: 28 / 42

26
Saving the setting values
This enables the values set for the items listed below to be stored together as a set with a title. Up
to four sets with titles can be stored.
What follows is an explanation of how to store these conditions.
Set the desired values for each of the items. Refer to the flowchart on page 20 to display the screen
for (7)-2. Use the
and keys to select a number from 1 to 4, and enable the choice by
pressing the
ENTER
key. Input a title for the setting values to be stored by using the and
keys to select alphanumeric characters and the and keys to move the cursor. The title may
be up to 12 characters in length. After inputting the title, press the
ENTER
key to enable the setting.
Items for which values can be stored are listed below.
Instruction set, Interface, Rotation, Baud rate, Data bit,
Stop bit, Parity, Handshake, Tool type, Tool-down
Speed, Tool-up speed, Pen change instruction control, Font,
Sheet weight, Cutting point compensation, User origin coordinates,
Coordinate units
Chacking the status of current settings
This is for confirming the conditions that are currently in effect. See the flowchart on page 22 for a
list of the items that can be confirmed. To move on to the next display, press the
, , , ,
or
ENTER
key. Pressing the
MENU
key returns the display to the screen for selecting [CONFIRM.]
Speed setting (While the tool is raised)
This screen sets the speed with which the tool is raised. If the speed for raising the tool is faster
than the speed for lowering the tool, the sheet may become misaligned during cutting. If this is the
case, set the speed to the same value as for lowering the tool. Also, holding down the
key when
making the setting cause a display known as the [COMMAND] screen to appear, When the setting
for this item is made, tool speed is according to the speed of the tool speed setting instruction (VS
instruction) sent from the computer. In such cases, the speed specified by the VS instruction takes
priority over the speed for lowering the tool set in step (4) -2.
Weight setting
The factory default setting is [LIGHT,] but this should be changed to [HEAVY] when cutting a
thick sheet. When set to [HEAVY,] cutting speed is slower and the load on the tool carriage is
reduced.
(7) -2
(8)
(9)
(10)