Front and Rear Panels
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
<About the Effect Controllers>
By rotating these knobs, you can control the UA-100’s onboard effects. The effect
parameters assigned to each knob will depend on the effect type. At the factory
settings, the knobs are assigned as follows.
fig.02-02.e
(This is also printed on the top cover of the UA-100.)
When the Effect Type Selector is switched, the various effect parameter values will
be reset to their default values regardless of the positions of the Effect Controller
knobs. You will need to rotate the Effect Controller knobs to adjust the parameters
once again.
By using the
UA-100 Controller
, you can edit the default values of the parameters.
For details, first install
UA-100 Controller
(p. 29), and then refer to
Help
for
UA-
100 Controller
.
For actual examples of use, refer to “Examples of Actual Applications” (p.
37).
You can use the
UA-100 Controller
to change the effect parameter assigned
to each
Effect Controller
. For details refer to
UA-100 Controller Help
.
When the effect type selector is in the
PC
or
BYPASS
position, the settings
of the Effect Controller will be ignored. If you wish to enable the Effect
Controller, set the Effect Type Selector to a position other than
PC
or
BYPASS
.
●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●●
MEMO
MEMO
Effect Parameter
Effect Type
13
Startup.e 15/6/99 18:42 Página 13
