Roland Aproll MDX-540, Руководство пользователя

Страница: 104 / 120

102
7-1 What to Do If...
The power does not come on.
Has the Emergency Stop button been pressed?
When the Emergency Stop button is depressed, the power does
not come on. Release the Emergency Stop button.

P. 40 "To Cancel an Emergency Stop"
Initialization is not performed or initialization fails.
Has the spindle cover been closed?
To ensure safety, no operation is performed while the spindle
cover is open. Close the spindle cover.
Is a large amount of cutting waste present?
Clean away any cutting waste. Clean especially carefully
inside the spindle cover and around the X, Y, and Z axes in
particular.

P. 94 "6-1 Daily Care"
Is anything caught on the spindle or table?
Check whether something has become caught and is imped-
ing initialization.
VPanel doesn't start correctly.
Has initialization been completed?
Before you start VPanel, first switch on the power to the ma-
chine.

P. 42 "3-2 Starting and Quitting"
Is the computer connected?
Check whether the connector cable has come loose.
Is the driver installed correctly?
If the connection to the computer is not made in the sequence
described, the driver may fail to be installed correctly. VPanel
does not function normally when driver is misconfigured.
Check again to ensure that the connection was made using
the correct procedure.

"Roland Software Package Software Guide"
Are two or more machines connected to a single
computer?
VPanel cannot control more than one machine at the same
time. When two or more machines are connected to a single
computer, you can control only one. When you're connecting
more than one machine, it is necessary to set the machine ID
numbers in advance.
For more information about machine IDs, refer to the VPanel
Online Help.

P. 23 "How to View the Online Help"
Operations are ignored.
Was the machine started according to the correct
procedure?
Simply switching on the power does not enable operation.
Start the machine using the correct procedure.

P. 42 "3-2 Starting and Quitting"
Is operation paused?
When the machine is paused, cutting stops and some opera-
tions are restricted. Cancel the paused state.

P. 54 "3-6 Pausing and Quitting Cutting"
Has the spindle cover been closed?
To ensure safety, no operation is performed while the spindle
cover is open. Close the spindle cover.
Is a large amount of cutting waste present?
Clean away any cutting waste. Clean especially carefully inside
the spindle cover in particular.
Is the handy panel connected correctly?
Before inserting of removing the connector cable for the handy
panel, switch off the power to the machine. The connection is
not detected if made while the power is on.
Is the driver installed correctly?
If the connection to the computer is not made in the sequence
described, the driver may fail to be installed correctly. VPanel
does not function normally when driver is misconfigured.
Check again to ensure that the connection was made using
the correct procedure.

"Roland Software Package Software Guide"
Are two or more machines connected to a single
computer?
VPanel cannot control more than one machine at the same
time. When two or more machines are connected to a single
computer, you can control only one. When you're connecting
more than one machine, it is necessary to set the machine ID
numbers in advance.
For more information about machine IDs, refer to the VPanel
Online Help.

P. 23 "How to View the Online Help"
Is VPanel displaying an error message?

P. 104 "7-2 Responding to an Error Message"
Chapter 7 What to Do If...