Roland Aproll MDX-540, Руководство пользователя

Страница: 77 / 120

4-5 Using the Tool Sensor

In VPanel, click the [Base Point]
icon.

If the machine is in the NC-code
mode, then select the desired coordi-
nate system.
Click [Start Detection].

WARNING: This procedure
makes the machine operate. Before
you perform this procedure, check
to make sure that operation of the
machine will not create any hazard
or danger.
Click [OK].
Clicking [OK] makes the tool slowly descend until it contacts the sensor.
When the tool rises and stops, the setting operation is complete.
To Make the Tool Descend Rapidly
When it takes a long time for the tool to make contact with the sensor, turn the hand wheel on the handy panel counterclock-
wise. Be careful not to make the tool collide with the sensor. A collision makes accurate detection impossible. If a collision
occurs, redo the operation from the beginning.
Operation Using the Handy Panel
You can also perform this operation using the handy panel.

P. 77 "Chapter 5 Handy Panel"
If the tool sensor is not detected, check the following points:
 Each cable is connected firmly.
 The front and back sides of the tool sensor are not reversed. (See the figure in the step.)
 No cutting waste and the like is present on the tool sensor, the terminal part of the sensor cable, and tool.
Click this when you want to stop the descent of the
tool before it reaches the target.
75
Chapter 4 Getting Ready for and Performing Cutting