9
3DISON PRO
User Manual V.1
C2. Setting up your 3DSION PRO
1. Make sure the power switch is Off. Locate the
power cord and plug it into the power input port at
the back of the 3DISON PRO. Plug the power cord
into an electrical outlet.
NOTE: The socket outlet must be located near the
equipment and must be easily accessible.
2. The on/off button (‘– | O’) of the 3DISON PRO is
located in the upper part on the back of the machine.
The ’O’ represents off and the ‘–’ represents on.
When the switch ON ‘–’ the 3DISON PRO is turned
on and should start up. Press the power button to
start.
NOTE: It is recommended to only turn off the
∃DISON PRO when it is NOT in use.
3. Once you see the LCD display as shown in the
picture, load filament and level your the printing
bed for the first time. You can load or unload filament,
or adjust the horizontality of the printing bed by
selecting the concerned menu Utilities.
Tip. LCD Display
●
Four Arrow buttons surround a central OK button.
Use the arrows to navigate through the LCD menus
●
OK button is to make selections.
●
The left arrow often allows you to go back or cancel
an action.
C. Unpacking and Setting up ∃DISON PRO
