13
3DISON PRO
User Manual V.1
D. Getting started:
Leveling the Build Plate and Filament Loading
D1. Leveling the Printing Bed
Leveling before 3D printing is so crucial that it can influence the quality of the print-out. If the
printing bed is too far from the extruder’s nozzles, or if one part of the bed is farther away from the
nozzles than another part, your 3D prints might not stick to the bed.
Meanwhile, if the printing bed is too close to the extruder’s nozzles, the bed can block the filament
from extruding from the nozzles. This can also scratch the printing bed and tear the PET tape on it.
When using Standard Leveling (manually adjusting)
2. Select
Utilities > Standard Leveling
on the
display menu.
3. Level the printing bed by adjusting the round
knobs each time when the extruder reaches to
the front, rear, left, right and center in sequence.
(Press the OK button so that the extruder move to
another point.)
NOTE:
●
At this time, it is important that you should turn the
round knobs as same degree as possible at the
same time using both hands.
●
If knobs are turned to the left, the gap between the
nozzle and the printing bed will increase. If knobs
are turned to the right, the gap between the nozzle
and the printing bed will decrease.
4. Upon completion of adjusting the round knobs each time when the nozzle reaches to
the printing bed in sequence, pull forward the A4 size paper and if the A4 size paper touch-
es the nozzle and slides with feeling of a little bit scratching, leveling has been completed.
Press OK button to finish the leveling.
NOTE: In CreatorK, uncheck the mark in the Auto-leveling item when generating Gcode.
1. Press the power button to start to adjust the
horizontality of the printing bed. Open the front
door and put a sheet of A4 paper onto the printing
bed before manual leveling.
NOTE: The thickness of A4 size paper is about
0.1mm and this paper is used in leveling the bed
to keep 0.1mm space between the nozzle and the
printing bed.
