RP208CN User’s and Installer’s Manual Page 33
A [STAY],
1
D [STAY],
4
B [STAY],
2
E [STAY],
5
C [STAY],
3
F [STAY],
6
"0" will not send a digit to the central station, to send "0" use "A" digit
Location: 06
Preparation
Location: 07
Preparation
Installer Code
：
Location 08-10
Location: 08
Installer Code I
Default: 0206
The installer code used by installer authorized to modify the system's parameters.
It is recommended to change the "factory default" Installer Code to one of your
own choice. It is made up by 4 digits.
Default
：
0206
Location: 09
Installer Code II
Default: 1206
Same as the
Installer Code 1, but with a few limitations: It can't modify the
"default code", observe and modify the first installer's codes, modify any phone
number, nor observe & modify MS lock code.
Location: 10
Master Code
Default: 1234
PUPROSE:
to establish the keypad code for the system's "chief user"; the
Master Code provides the following special privilege:
1. Alter the master code and users’ code
2. Setting the clock
；
3. Checking the trouble and the events record or other operation
4. System testing
；
5. Set follow-me phone number
Note:
the Master Code cannot be seen by the installer through the keypad.
System Time
：
Locations 11-13
Location: 11
Exit Delay
Default: 030
Location 11 is used to set the time of exit delay, which unit is second. The time of
delay is made up of 3 digits, 1 second at least, 255 second at most. For example,
030 means the delay time is 30 seconds. When arm, it won’t alarm to leave the
