Commissioning
R&S
®
TS-PWA3
38
User Manual 1157.8143.12 ─ 17
Note:
Do not unscrew the rear four feet as this will loosen the body of the case!
4. Affix the self-adhesive plastic slide rails.
5. Place the unit into the rack on prepared aluminum rails.
6. Fix the R&S TS-PWA3 by screwing the "19 inch side brackets" to the rack.
Note:
Check the position of the locknuts in the rack before sliding in the R&S TS-
PWA3.
If required, insert and attach filter mats above and below the TSVP.
An optional
telescopic rail
set is also available. The telescopic rails are fitted to the
side of the “BW 2000” case. The R&S TS-PWA3 can then be pushed into the prepared
support in the rack.
4.2.3
Desktop Setup
When the R&S TS-PWA3 is set up on a desktop, the minimum gap under the unit is
provided by the feet on the "BW 2000" case.
Do not obscure the ventilation louvers on the top of the unit! The minimum clearance of
half a height unit must be ensured!
4.2.4
Operating Position
The Test System Versatile Platform R&S TS-PWA3 can be operated in the following
operating positions:
●
Normally, upright on the device bases on the bottom of the device
●
Supported on the rear bases (on the bases holding the tube)
●
Any tilt angles between the two above positions are possible.
For operating positions 2 and 3, follow the instructions according to
Setting Up
