Operation
R&S
®
ATS1000
52
Instructions Handbook 1179.2983.02 ─ 01
365
mm and 245
mm, including the circular ABS polymer base with diameter 128
mm.
The metal base plate (labeled 5 in
) on which the tower stands adds an addi-
tional 10
mm to the tower's overall height. The rectangular table top has 2 adjustable
clamps to fix a DUT.
Figure 7-7: Rohacell DUT holder with table top and adjustable clamping fixtures
1 = Rohacell holder with DUT (example) mounted on the table top
2 = Square towers, height 365 mm and 245 mm, with 4 screw holes for fixing the table top
3 = Since the solid tower has no through bore, cables are fed through the lower and upper holes
4 = 2 adjustable DUT holder fixtures on the table top
5 = Tightening the polymer screws that lock the adjustable fixtures
Prerequisites for fixing your DUT to the Rohacell DUT holder:
●
has assembled the holder to a height at which your DUT is to a
height at which your DUT is approximately level with the rotational axis of the
antenna positioner arm.
●
has screwed the holder to the turntable.
●
has threaded all cables required for connecting the DUT through
the holder and close to the DUT's position.
To place the DUT on the holder
► See
"To place a DUT in the chamber"
To clamp the DUT on the holder
1. Loosen the 4 polymer screws of the adjustable fixtures (labeled 4 in
2. Move the fixtures so that they are wider apart than the width of the DUT.
3. Carefully position the fixtures such that the DUT is clamped at the center of the
holder.
4. Lock the fixtures in position by tightening the screws finger-tight (5).
7.4.5
PCB Holder Set
Only an
is allowed to mount and configure DUT holders. An
use the DUT holders as configured.
The PCB holder set (order no. 1534.9601.00) is delivered with the R&S
ATS-AZTAB2.
It can be used also with the R&S
ATS-AZTAB1.
Placing a DUT in the Chamber