Installation and Operation Manual 90DIB500IM02 – 5.2
79
DIB-500 R4.1
Commissioning
Connection to the electrical system
5.1 Connection to the electrical system
The following section describes the procedure for connecting the product/system to the
electrical system properly.
5.1.1
Tools and aids
The following tools and aids are required for connecting the product to the electrical
system:
|
M13 ring spanner
|
Size 4 Allen wrench
|
No. 1 Phillips head screwdriver
|
Phillips head screwdriver size PH2
|
Size 3 mm screwdriver
|
TETRA antennas required (A and, optionally, B)
|
GPS antenna incl. accessories from the scope of delivery
|
Coin to unscrew/tighten the mounting screws of the equipment rack top cover
|
Cable end sleeve calliper
|
Cable end sleeves
|
Connecting cable from the scope of delivery for connecting the cavity coupler (for
cavity variant only)
5.1.2
Connection with the grounding system
The network and hardware components installed in the equipment rack are already
grounded through the equipment rack. Before you can connect and switch on the volt-
age supply, however, you must first connect the equipment rack to the grounding sys-
tem.
For connection with the grounding system, a grounding connector for the grounding
cable (green-yellow) has been provided below the top cover of the equipment cabinet.
