Installation and Operation Manual 90DIB500IM02 – 5.2
129
DIB-500 R4.1
Commissioning
Function tests DIB-500 R4.1
10. Enter the following commands one after the other to disable the voice channels on
the first carrier of the DIB-500 R4.1:
p s lnsw slsw 10 04 00
p s lnsw slsw 10 03 00
p s lnsw slsw 10 02 00
11. Re-establish voice communication using the two radio sets.
12. Check whether both the radio sets can send and receive voice transmissions.
13. Terminate the voice communication.
14. Enter the following command to enable the voice channels that you disabled
before:
p s lnsw slsw 10 xx 17
xx corresponds to the voice channel on the respective carrier
15. Enter the following command to restart the TOS component:
g quit
➥
The TOS component terminates the TELNET connection to the service laptop
and restarts.
✓
The check of the voice channel is complete.
Variants with more than two Carriers
For a DIB-500 R4.1 with more than two carriers, the function test must be continued as
described in section 5.9.3.2 on page 129 .
5.9.3.2
Checking the voice channel (more than two carriers)
Checking the voice channels of a DIB-500 R4.1 with more than two carriers requires
further work steps in addition to the procedure described in section 5.9.3.1 on page 127.
The procedure for checking the voice channel is described in the following.
Checking the Voice Channel
Preparation:
✓
You need the tools and aids described on page 123.
✓
The ON/OFF switches in the connection panel must be in the "On“ ("top" switch
position) position.
✓
The SMT and the service computer must already be connected, refer to section
5.7.2.3 on page 123.
Carry out the following steps:
1. Perform the work steps step 1. to step 13. in section 5.9.3.1 on page 127.
2. Enter the following command to disable the fourth carrier:
bsce block 2
3. Establish voice communication using the two radio sets.
4. Check whether both the radio sets can send and receive voice transmissions
