Rohde & Schwarz CMW-KM645, Руководство пользователя

Страница: 32 / 65

Command Reference
R&S
®
CMW-KM645
32 User Manual 1173.9740.02 ─ 04
6 Command Reference
The following sections provide detailed reference information on the remote con-
trol commands of the "FM Stereo Radio Measurement" application.
● Conventions and General Information .................................................................... 32
● Signal Routing and Analyzer Settings .....................................................................37
● Measurement Control and States ........................................................................... 40
● Measurement Control Commands .......................................................................... 42
● Limits .......................................................................................................................48
● Measurement Results ............................................................................................. 51
6.1 Conventions and General Information
The following sections describe the most important conventions and give general infor-
mation concerning the command reference.
6.1.1 MEAS<i>
MEAS<i> is used as abbreviation of "MEASurement<instance>". For better readability
only the abbreviated form (which is also accepted by the instrument) is given in the
command reference.
The <instance> is relevant for instruments supporting several instances of the same
firmware application. It can be omitted if the instrument supports only one instance, or
to address the first instance.
See also: "Firmware Applications" in the R&S CMW user manual, chapter "Remote
Control"
6.1.2 FETCh, READ and CALCulate Commands
All commands are used to retrieve measurement results:
●
FETCh...
returns the results of the current measurement cycle (single-shot mea-
surement) after they are valid.
FETCh...
must be used after the measurement
has been started (
INITiate...
, measurement states RUN or RDY).
●
READ...
starts a new single-shot measurement and returns the results.
●
CALCulate...
returns one limit check result per
FETCh
result:
– OK : The
FETCh
result is located within the limits or no limit has been defined/
enabled for this result.
– ULEU (User limit exceeded upper): An upper limit is violated. The
FETCh
result
is located above the limit.
– ULEL (User limit exceeded lower): A lower limit is violated. The
FETCh
result is
located below the limit.
Conventions and General Information
深圳德标仪器
135-1095-0799