EN
53
From 3 to 90 s. The light remains lit for the time period set after the manoeuvre is completed.
From 2 to 9 minutes. The light remains lit for the time period set after the manoeuvre is completed.
'PSGOGSRXEGXGSRƼKYVEXMSR
(ORO)
When the clock function is active, the gate opens and remains open.
At the end of the programmed time set with the external device (clock), the gate closes.
N.B.:
This parameter is not visible if
$
and
.
When the clock function is active, the gate opens and remains open. Any command signal received is
ignored.
When the clock function is active, the gate opens and remains open. Any command signal received is
accepted. When the gate returns to the completely open position, the clock function is reactivated.
Enable safeguarded gate closure/opening
)REFPMRK XLMW TEVEQIXIV IRWYVIW XLEX XLI KEXI MW RSX PIJX STIR HYI XS ER MRGSVVIGX ERHSV EGGMHIRXEP
command.
This function is NOT enabled if:
• the gate receives a STOP command;
• the sensing edge is activated;
• the number of closure attempts set by parameter
$
has been reached;
• the acquired position is lost (perform position recovery, see chapter 16).
Disabled. The parameter
is not displayed.
Safeguarded closure enabled.
After a period of time set with parameter
XLIGSRXVSPYRMXWMKREPWEWIGSRH[EVRMRK[MXLXLIƽEWLMRK
light, regardless of the parameter
$
, and then closes the gate.
7EJIKYEVHIHGPSWYVISTIRMRKIREFPIH
If the gate is closed as a result of a step mode command, after a period of time set with parameter
,
XLIGSRXVSPYRMXWMKREPWEWIGSRH[EVRMRK[MXLXLIƽEWLMRKPMKLXVIKEVHPIWWSJXLITEVEQIXIV
$
), and
then the gate closes.
If the gate is stopped by the obstacle detection system during a closure manoeuvre, the gate closes after
a period of time set with parameter
.
If the gate is stopped by the obstacle detection system during an opening manoeuvre, the gate closes
after a period of time set with parameter
.
Setting safeguarded closure/opening activation time
N.B.:
this parameter is not visible if the value of parameter
=
.
Wait time settable from 2 to 90 s.
Wait time settable from 2 to 9 min.
Restoring factory default values
NOTE
This procedure is only possible is NO data protection password is set.
P1
P2
x4 s
Warning!
6IWXSVMRKHIJEYPXWIXXMRKWGERGIPWEPPWIXXMRKWQEHITVIZMSYWP]I\GITXJSVTEVEQIXIV
$
: after restore, check
that all parameters are suitable for the installation.
The default factory settings may also be restored using the
S
(up arrow) and
T
(down arrow) buttons as follows:
• Turn off the power.
• Press and hold the
S
(up arrow) and
T
(down arrow) button until the unit switches on.
• The display flashes after 4 s
U(V
.
• The default factory settings have now been restored.
