Rodgers Trillium T797, Руководство пользователя

Страница: 73 / 100

62
3. Rotate the Alpha dial to select the desired setting (
Off
,
Sust
,
Sost
, or
Soft
)
4. Press either the flashing MIDI coupler or the General Cancel to exit.
The Foot Switch Function selection procedure is complete. Combination pistons
which are set while the MIDI coupler is activated will also store this setting. A MIDI
Save may be performed to save this setting as the default. See “MIDI Save” on page
75.
Reverb
An independent reverb level (from 0-127) may be set for each MIDI coupler. This value
controls the reverb within the MIDI device itself, not the RSS

Room Modeling system
within the organ.
Setting the Reverb Level for a MIDI Coupler
To set the Reverb value for a MIDI coupler:
1. Hold SET and press the MIDI coupler piston. (The MIDI coupler will flash).
2. Rotate the Select knob to highlight the
Reverb
parameter in the display:
M I D I C o u p l e r G T A
P a n
F o o t S w
R e v e r b
0
O F F
0
3. Rotate the Alpha dial select the desired Reverb value.
4. Press either the flashing MIDI coupler or General Cancel (‘ 0 ’) to exit.
The Reverb selection procedure is complete. Combination pistons which are set
while the MIDI coupler is activated will also store the Reverb value. A MIDI Save
may be performed to save this setting as the default. See “MIDI Save” on page 75.
Instead of saving, you may press and hold General Cancel (‘ 0 ’) and momentarily press
SET to return MIDI couplers to their defaults. This Reset procedure also returns
Voice Palette selections to their defaults.
To avoid possible distortion, do not use very high reverb levels.
!
Instead of saving, you may press and hold General Cancel (‘ 0 ’) and momentarily press
SET to return MIDI couplers to their defaults. This Reset procedure also returns
Voice Palette selections to their defaults.
!