Rodgers Trillium T797, Руководство пользователя

Страница: 41 / 100

30
Inserting a SmartCard
To insert a SmartCard so that it can be used:
1. Insert the card firmly in the slot with the gold contacts facing down. The red LED
will light for a few seconds as the contents of the card are loaded into the organ.
Saving to a SmartCard
A new card contains no combination memories. As long as an empty card is inserted in the
T797, the organ uses the internal memory when recalling pistons. As soon as pistons are
saved to the SmartCard, however, the card will be used rather than the internal memory.
To save registrations onto a SmartCard:
1. Select the desired memory level by pressing pistons M1 , M2 , M3 or M4 .
2. Set any piston in the normal manner by holding SET, then pressing a combination
piston.
The piston will be saved to the SmartCard, along with all other pistons in the active
memory level.
The contents of the entire memory level ( all pistons) have now been copied to the
SmartCard. Because the card now contains a copy of the currently selected memory, the
card memory is now used instead of the internal memory from this point. Setting a piston
now affects only the card memory and not the console internal memory. This is true until a
different memory level is selected or until the SmartCard is removed. It is important to
remember the following points:
•
When a SmartCard is in the slot, any memory levels existing on the card replace the
corresponding instrument console internal memory, which is temporarily suspended.
•
Setting any piston while a SmartCard is inserted copies the current memory level to
the SmartCard if it did not already exist on the card. The SmartCard must be
removed in order to set pistons to internal memory levels.
•
When a memory select piston ( M1 , M2 , M3 or M4 ) is pressed and held, a message
appears in the Console Display indicating whether the internal memory or the
SmartCard memory is being used.
To save internal memory settings to your SmartCard without changing any piston
settings, press a piston to recall its combination, then hold SET, and press the same
piston again. This will transfer the internal memory to the SmartCard.
!