Rodgers Trillium T797, Руководство пользователя

Страница: 59 / 100

48
Room Modeling
The sound we normally hear allows us to perceive the distance from the sound source because it
is a combination of two different types of sounds: The sound that reaches our ears directly and
the sound that reaches us with some delay after it reflects off of walls and other surfaces. A
component of Dimensional Sound Modeling, the
Rodgers Sound Modeling™ system allows
you to specify the acoustic you desire for the T797.
Room Modeling does much more than add simple decay to the sound of the instrument, it uses
leading-edge technology to go beyond three-dimensional sound and create a sense of distance,
shape and ambience to what is heard in the room. What’s more, the menu system is extremely
descriptive and intuitive.
The Room Modeling menus allow you to specify the size of room and type of wall covering for
the T797 acoustic. For example, if you wanted to hear the instrument in a large room, you could
select “
Large Church ” or “ Cathedral ”; if you wanted to change the wall covering from a soft
to a hard material, you could select “ Concrete ” or “ Marble ”.
It is also possible to change the amount of acoustic treatment heard in the room using the Reverb
Level control.
Adjusting Room Modeling Settings
To change the Room Modeling Settings:
1. Press and release QUICKMENU .
2. Rotate the Select knob to highlight
Room Modeling
.
3. Press and release QUICKMENU to select the Room Modeling category.
4. Rotate the Select Knob to highlight desired setting: Room Size , Wall Type or
Reverb Level
.
5. Press QUICKMENU to select the setting.
6. Rotate the Alpha dial to change the setting.
7. Press General Cancel (‘ 0 ’) to exit.
You can preview the changes by playing the organ while adjusting the setting.
Normally, these changes are temporary. However, you can perform an Audio Save so that
the changes are retained when the instrument is turned off. See Audio Save on page 45.