QCI0150 REV. 0
Page 9 of 14
Certified 06/04/10
9
10
Place 1/8” setting blocks [20] into the U-channel as shown or approximately every 18”.
DO NOT
place setting blocks over screw heads, but set them close to ensure that
the screw heads are below the setting blocks.
Using suction cups set, the Stationary
Glass Panel into the U-channels on the
appropriate side. Use different sizes of
setting blocks to make exposed edges
of the glass level and plumb.**
Exposed edges
MUST
be level and plumb
before moving to next step.
**Different sizes setting blocks may be
required depending on level conditions.
Various sizes of setting blocks are provided
and can be used in different combinations
(stacked) to obtain the desired result.
Loosen screw
but do not remove it
SETTING BLOCK
U-CHANNEL
HEADER
STATIONARY PANEL
Remove the Anti-jumper from the Clamp [8]. Loosen the Clamp screw but do not remove it.
ANTI-JUMPER