Matrix
III E
H
EM-Marine / HID ProxCard II 125KHz RFID reader
with connection via iButton (1-Wire) / Wiegand-26 protocols
User Manual
1. GENERAL INFORMATION
Matrix
III EH Reader
is
used in Access Control Systems (ACS). The reader transmits into the
controller the codes of EM-Marine or HID
ProxCard II
tokens (cards or key fobs) presented to it, via
iButton (Dallas Touch Memory) or Wiegand-26 protocols.
2. OPERATION
The reader operation without activating external indication control (i.e. staying under internal
indication control):
1. In standby mode, the red LED shines solid.
2. On card approach, the red LED goes off and the green LED flashes once, and a short beep
sounds.
3. While the card remains within working zone, no LED indication is provided.
The external indication control for the LEDs and the buzzer is initiated by connecting corresponding
terminals to common ground. The external indication control for one mode can be used with internal
indication control for another; if, for instance, external indication signal for LEDs is activated, the
LEDs get under external control, while the buzzer remains under internal control.
3. MOUNTING AND CONNECTION
To mount the reader, perform the following sequence:
- Mark and drill the mounting holes per Fig. 2;
- Connect the reader wires
according to
Table 1;
- Insulate all wire junction points;
- Power up the device (the red LED will come on);
- Test the reader operation by touching it with a token;
- Mount the reader in its desired place and fix it with screws;
- Install the decorative cover and fix it with a screw.
Note 1: Leave 10 cm or more between any two readers.
Note 2: To achieve the specified distance from controller, a UTP cable (e.g. CAT5e compatible)
must be used as follows:
- When using iButton protocol, one wire from the twisted-pair should be connected to GND and
another to DATA0 terminal.
- When using Wiegand 26 protocol, the first twisted pair is connected between GND and DATA0,
and the second one between GND and DATA1, as per Fig. 1.
page 1
MATRIX III EH
www.ironlogic.
me
