QCI0150 REV. 0
Page 10 of 14
Certified 06/04/10
Slide the Clamp [8] over the glass panel and the Header [1] with the screw on the inside of the shower.
Set a distance between the exposed glass edge and the Clamp [8] equal to 1/4” then tighten the screw.
12
1/4"
View from Inside Shower
DOOR WIDTH
HEADER
WALL MOUNT HEADER
BRACKET
CLAMP
11
Measure the width of the Door Panel
.
Place a mark on the threshold
measuring the same distance from
the open wall (See illustration). Place the Guide [11] on the door side of the mark and against inside face of
the U-channel. Mark the location of the two mounting holes of the Guide onto the threshold
.
Next, drill two 3/16” diameter holes at the marked locations. Insert a small amount of silicone into each drilled
hole and insert a wall plug into each hole. Then, carefully cut heads off of the wall plugs with a razor blade
so there is nothing raised above the surface of the threshold. Place Guide [11] in correct position and secure
it with #8 x 1-1/2” truss head screws [18].
#8 X 1-1/2”
TRUSS HEAD SCREWS
WALL PLUGS
View from Inside Shower
View from Inside Shower
GUIDE
STATIONARY PANEL
GUIDE
U-CHANNEL
Take the Roller with Stopper Pin [9] and set the roller cam shaft by loosening
a set screw with the 4mm Allen wrench and rotate the cam shaft to set the
adjustment hole to horizontal then retighten the set screw.
Do the same steps with the Roller [10].
Remove mount bolts and washers before mounting the Roller
Assemblies [9/10] to the Door Panel.
Note: The Rollers [9/10] have
+/-
1/8” height adjustment.
STATIONARY PANEL
4mm ALLEN
WRENCH
ROLLER CAM
SHAFT
Adjustment
Hole
MOUNT BOLTS
