QCI0150 REV. 0
Page 13 of 14
Certified 06/04/10
20
18
19
Place the Bottom Catch [12] onto the bottom of the Door Panel approximately 1/4” from the edge
of the door. Completely close the door and adjust location of the Bottom Stopper (see illustrations). Mark its
location on the glass (a small peace of tape works best). Remove the Bottom Catch and apply a small amount
of silicone to the inner surfaces of the Catch. Place the Catch back onto the glass at its marked location.
Run a small bead of silicone where the glass and the Bottom Catch meet on the inside of the Door Panel.
1/4”(
approx.)
Location of the Bottom Catch
when the Door Panel completely closed
GUIDE
SPRING
DRIP VINYL
DOOR PANEL
STATIONARY
PANEL
Place 18” Pull/Knob [13] or Back to Back Knob [13]
on the Door Panel (see pictures).
18” PULL
KNOB
BACK PLATE
WASHER
BUSHING
KNOB
KNOB
WASHER
BUSHING
18” PULL/KNOB
BACK TO BACK KNOB
Measure the distance between the wall and the Stationary Panel.
Then cut the Filler [4] to the measured distance. Run a small bead
of silicone along both sides of the Filler [4]. Then insert the Filler
into the U-channel [2] (see illustrations).
Run a small bead of silicone
along these edges.
FILLER
U-CHANNEL
U-CHANNEL
FILLER
STATIONARY
PANEL
DOOR PANEL
The spring in Guide [11] can also be slightly adjusted using an Allen wrench.
Run a small b
ead
of silic
one
