Rockwell Automation iTRAK, Руководство пользователя

Страница: 42 / 124

42 Rockwell Automation Publication 2198T-UM002C-EN-P - March 2019
Chapter 2 Track Installation
What You Need
7/16 in. open-end wrench
Mount the Lubricator Pumps
To mount the lubricator pumps, complete these steps.
1. Locate a mounting position for the pumps.
The pump must be located within the 10 m (32.8 ft) of tube routing
distance to the iTRAK system lubrication connectors and 5.0 m
(16.4 ft) of the power cable routing distance to 24V I/O port of your
controller. The location must be accessible for maintenance and visible
for monitoring the pumps status indicators. Observe the clearance
requirements that are shown in
Figure 18 .
2. Adjust the beam clamp to accommodate the attachment surface by using
a 7/16 in. open-end wrench.
The beam clamp can be positioned anywhere on the H pattern of the
mounting clamp.
3. Attach the lubricator pumps to their mounting surface by the beam
clamp by using 7/16 in. open-end wrench.
4. Label, route, and secure the tubes from the pumps to the lubrication
connectors on the iTRAK system.
5. Remove the plug from the lubricator pump connector and immediately
replace with the tubing.
To remove the plug, pull back on the connector face and pull out the
plug.
6. Repeat step 5 for the two other pumps and at each connector on the
iTRAK system.