ROBWAY RCI-4100, Эксплуатация и установка

Страница: 34 / 187

OPERATION AND INSTALLATION
RCI-4100 SYSTEM
MAN-1111 Rev H ©Copyright 2015 LSI-Robway Pty Ltd Page 34
3.4.4.
FUNCTION PUSH BUTTONS
There are five push buttons on the lower part of the display as follows:
LOAD - Used for switching between Main Winch and Aux Winch. Although the
system will always check on the safe operation for both winches, it is
important to ensure that the correct winch is selected as the winch
selection affects the values shown on the display. When the actual load
exceeds the SWL for the current crane configuration, the RCI-4100 will
activate audible and visual alarms.
SETUP/CANCEL - Multi-purpose button used for accessing Calibration Mode (SETUP) in
conjunction with the over-ride key switch, for changing Duty and Falls,
and for aborting changes (CANCEL) to calibration data values during
calibration/setup
( refer to Section 7. “Calibration” for details).
TARE/ENTER - Dual-purpose button used for activating tare function (TARE) and for
confirming changes (ENTER) to calibration data values during
calibration/setup. Refer also to previous sections for details on the Tare
function.
UP/DOWN ARROW - Used for changing Duty and Falls when on normal operating screen.
When in Calibration Mode, these keys are used for going through the list
of Function Codes and for incrementing/ decrementing numerical values
when calibrating/setting up a function.
3.5. Restricted Slew Zone Monitoring – Optional Feature
Restricted Slew Zone Monitoring is an optional feature that can be integrated into the RCI-4100
system if required.
This option can provide two forms of Restricted Slew Zone Monitoring:
• Built-in slew alarm and cut-out when approaching permanent structures, and
•
Operator settable alarm for temporary structures or obstacles.
Slew zones are settable both by slew position and boom angle.
If this option is supplied, please refer to APPENDIX H, Restricted Slew Zone Monitoring Option for
usage information and details.
3.6. Wind Speed Monitoring – Optional Feature
Wind Speed Monitoring is an optional feature that can be integrated into the RCI-4100 system if
required.
If this option is supplied, please refer to APPENDIX I, Wind Speed Monitoring Option for usage
information and details.
3.7. Wind Direction – Optional Feature
Wind direction is an optional feature that can be integrated into the RCI-4100 system if required.
If this option is supplied, please refer to APPENDIX J, Wind Direction Monitoring Option usage
information and details.
3.8. Gross Over-moment Protection (GOP) – Optional Feature
Gross Over-moment Protection is an optional feature that can be integrated into the RCI-4100 system
if required.