RoboVent Spire MLS-01-5500-10, Руководство пользователя

Страница: 57 / 68

ROBOVENT • SPIRE SERIES OWNER’S MANUAL 57
SECTION 1000
Troubleshooting
iv. Allow smoke alarm to soak for approximately 10 minutes (longer if
extremely dirty). Then agitate for 5-10 seconds to flush out any remaining
dirt left inside smoke alarm’s housing.
v. Remove smoke alarm from wash water and transfer directly to one of the
first rinse buckets containing clear water. Again, allow smoke alarm to
become completely submerged, agitate once more for 5-10 seconds to
remove soap residue.
vi. Finally, transfer smoke alarm to your second and final rinse bucket,
repeating method found in the previous step, then remove smoke alarm to
a clean dry area to thoroughly dry before reinstalling. You can use Low pSi
compressed air to expedite the drying process.
g. Run blower for 2-4 minutes without cutting and/or welding process active to
exhaust dirty air.
h. If alarms continue to sound even after all the above has been tried, you may
need to replace your smoke detector. Call RoboVent at 888-762-6836 for
support.
*This is a recommendation only. In the event of a fire, follow your state/local/company
firefighting procedures.