RoboVent Spire MLS-01-5500-10, Руководство пользователя

Страница: 45 / 68

ROBOVENT • SPIRE SERIES OWNER’S MANUAL 45
SECTION 900
Maintenance
Filter Change
Filter condition is the key to maintaining clean air and
an efficient dust collector. Filters, over time, will load
with particulate and either need to be pulse cleaned
or replaced. Due to application, system design, type
of particulate collected, and usage levels you may see
a drop in performance when the filter pressure reads
4" to 6" I.W.C. after a full offline cleaning. At this point
filter replacement could be warranted.
1. Turn blower and system off. (see Figure 40).
2. Turn power to the machine off using disconnect on
the control panel door. Lock out. (see Figure 41).
3. Lay out protective floor covering below door area
for simplified clean-up.
4. Open filter door. Brush any built up debris from
the door area into the hopper. (see Figure 42).
5. The filters are removed from the unit by turning
the filter handle counter clockwise.
6. Remove filters individually, properly containing each
filter as they are removed. Dispose of according
to local regulations and according to processes
determined as a result of dust toxicity testing.
7. Use a long-handled brush to sweep inside wall of
cabinet and debris down into the dust drawer. (see
Figure 43).
8. Take care not to get dust into the clean air side.
9. Empty and replace the dust tray.
FIGURE 41
FIGURE 43
FIGURE 42
FIGURE 40