RoboVent Spire MLS-01-5500-10, Руководство пользователя

Страница: 24 / 68

24 ROBOVENT • SPIRE SERIES OWNER’S MANUAL
SECTION 500
Installation
FIGURE 21
FIGURE 22
FIGURE 23
Intake Damper Installation (option)
Optional Accessory that comes with Supprex-200
System (If not pre-assembled onto unit at factory)
(see Figure 21).
Refer to your engineering drawing to determine where
to mount the intake damper on your system. Typically,
the intake damper will be located directly on the
intake or spark arrestor as close as possible to the unit.
Utilize these instructions to ensure your intake damper
is connected appropriately both pneumatically and
electrically. This damper is critical to have in place
in order for the installed fire suppression agent to
perform in the event you have thermal event.
• Mount the pneumatic blast gate in place.
• The blast gate should already have the tubing
connected and Coil mounted to it .
• If there is a reed switch there is no need to install.
• You will need to connect both ¼ inch tubing
(regulated from 80-90PSI) to the solenoid valve, and
the wiring to the Din connecter.
• See Figure 22 for the ¼ inch tube connection.
See Figures 22 & 23 for Din connecter wiring.
• Circled in red on Figure 22 is where the connection
from the ¼ inch tubing will be connected this will
need to be regulated from 80-90 PSI.
• Highlighted in blue in Figure 22 identifies where
to locate the Din Connector and the Voltage
requirement to power the valve.
(24VAC 7.1VA 50HZ - 5.8 60HZ)
• Refer to Figure 34 for proper wire placements.
1 = red wire (24VAC)
2 = white wire (neutral)
G = green wire (ground)