Robotronics Vehicle Robot, Руководство по эксплуатации

Страница: 8 / 81

4
Setup and How to Operate the Robot
1 Read the manual
Read and study this manual completely before operating the robot. If you have any questions
about operation of the robot, call our service group.
2 Charge the batteries
Be certain that the robot battery and radio control transmitter battery are fully charged before
operating the robot.
Install the robot battery. Open the rear door or trunk to gain access.
1. Put the robot battery in the compartment in the back.
2. Connect the robot battery connector to the robot connector. Red will go to red and black to
black. This connection is polarity protected and can be connected only the correct way.
3. The battery is secured in place with a battery strap. Tighten the strap very tight.
CAUTION
The robot battery posts should never contact the metal of the main electronics box or the
metal of the drive base. This will result in damage to electronic components especially
inside the main electronics box.
3 Attach the upper robot to the lower
1. Set the upper robot on the lower robot body.
2. As you put the top on, connect the 37-pin connector, which is a round connector and wire
bundle running from the upper robot to the lower robot. When connecting this rotate it until it
sits down into its mate connection and turn the plastic ring until it is secure.
3. Locate the four body latches (just two on certain robots) and push
the pins into the body to secure the upper robot to the lower. If you
have a Character driving, two of the latches are located in the
compartment where the Character sits. The pins are to the left and
right of Character. The other two are at the back of the robot. To
latch these you will need to reach in through the back trunk or
door. If you want to see a picture of the latches see page 5.
Getting Started