Robopac Rotoplat DW 108-508, Руководство по эксплуатации и обслуживанию

Страница: 43 / 88

- 39 -
B
D
C
A
E
G
F
Rotoplat DW 508
Rotoplat DW-C 508
14C214030
English
- 39 -
Chapter 5
INFORMATION ON ADJUSTMENTS
The table lists the pre-stretch values obtainable with the relevant
driving ratio.
Important
Set the pre-stretch depending on the resistance and the quality
of the coating to obtain low consumption.
Table 5.1.:
Pre-stretch values.
Pre-stretch
percentage
Gear code
(L)
No. of gear teeth
(L)
Gear code
(N)
No. of gear teeth
(N)
150% 2540300068 34 2540300070 85
200% 2540300003 29 2540300002 90
250% 2540300165 25 2540300164 94
300% 2540300027 24 2540300028 95
15. Assembly the small plate and correctly fix it to the gear of the new
driving ratio.
16. Assembly the gear of the new driving ratio.
17. Position the gear with the side of the small plate coupled to the
friction.
18. Assembly the stopping ring.
19. Assembly the gear of the new driving ratio.
20. Assembly the stopping ring.
21. Assembly the pulley.
22. Assembly the stopping ring.
Important
During re-assembly remember to pay attention to the proper
insertion of the coupling tabs.
23. Rest the disk (F) on the little
columns paying attention to
assemble the belt (C) on the
pulley (D) .
24. Tighten screws (E) .
25. Tension the belt
(C)
through the
tightener
(B)
.
26. Rotate manually the pre-stretch
rollers in both directions to
completely adjust the coupling
between the belt and the pulleys.
27. Again check the tension of the belt
and if needed strain it properly.
28. Re-assemble the casing (A) at
the end of the operation.