ORBIT 16
1.
Press the key
(A)
to align the various
parts (rotating ring, pressure units) (see
6.9.
“Machine boot” - “Timing of the
rotating ring”).
2.
If necessary, remove the product to be
wrapped or partially wrapped by the
machine.
3.
If necessary, block the film in the clamp
(see
6.9.
“Machine boot” - “Coating
insertion inside the gripper”).
The machine is ready to start a new
operating cycle.
6.11.3. PRODUCTION END STOP
This situation verifies when the work
shift or machine use is over or when the
machine remains inactive or not
attended to for a certain lapse of time.
1.
Turn the main switch to position
0
.
6.11.4. EMERGENCY STOP
Press the EMERGENCY button.
Machine operation stops immediately.
After having normalized the working conditions, unblock the emergency stop button to allow machine
operation.
If you wish to continue the winding that was interrupted, you must press the START button.
If a new operation is to be started, proceed as follows:
1.
Remove product from the machine.
2.
Press the key
(A)
to synchronize the
machine or press the "Reset" push-
button.
3.
Block the film inside the clamp (see
6.9.
“Machine boot” - “Coating insertion
inside the gripper”).
The machine is ready for a new wrapping
cycle.
80/95
